Fire resistant sealing compound for linear joint and gap seals The new HENSOMASTIK® Acrylic is a ready-for-use acrylic based liquid filler especially designed to form a fire penetration seal in linear joints and gaps where wall and floor constructions made…
Solvent free 2C fire protection coating system for interior and exterior use Tested according to EN 13381-8 and approved according to EN 13501-2 ETA-21/0475, CE marking in accordance with 93/68/EEC Approved in accordance with BS 476, Certifire No. CF 5994…
Fire protection solution for electrical installation boxes and power sockets In general, fire protection walls must not have any openings, but in practice it is sometimes unavoidable to route electrical supply lines through it or to place electrical installation boxes…
HENSOTOP WB Green is a single component water-based top coat for HENSOTHERM® water-based fire protection coatings for indoor use. Substrates / Properties VOC 3,5 g/m² | nominal stratum thickness acc. to Technical Data Sheet Fast drying coating based on water-based…
HENSOTHERM® V 55 is a cleaning thinner for the 2C fire protection coating HENSOTHERM® 920 KS. It is used for pre-cleaning and intermediate cleaning in case of a longer work interruption as well as for cleaning the equipment and working…
Water-based 1C system, maintenance-free, for indoor use Approved in accordance with BS 476 Certifire No. CF 5678 Main uses Structural steel profiles as columns / beams / girders / I- / H-sections Open steel profiles: R15 – R60 for beams…
Solvent-based 1C system, maintenance-free, for indoor and outdoor use Tested according to EN 13381-8 and approved according to EN 13501-2 ETA No.: 20/1259, CE marking in accordance with 93/68/EEC Colour: RAL 9002 Main uses Open profiles R30 – R60 for…
HENSOTHERM® V 60 is a thinner and used to adjust the viscosity of the solvent-based fire protection coating HENSOTHERM® 310 KS rapid and to clean the equipment after use. HENSOTHERM® V60
HENSOTHERM® V 84 is a thinner and used to adjust the viscosity of the HENSOTOP 84 AF and HENSOTOP 2K PU top coats and to clean the equipment after use. HENSOTHERM® V84
Water-based 1C system, maintenance-free, for interior use Approved in accordance with BS 476 Certifire No. CF 5344 Main uses Open sections and closed hollow sections R15 – R180 Environment Contains no halogens, APEO, borates or plasticisers Non-VOC, LEED v4 Environmental product declaration…