Fire resistant sealing compound for linear joint and gap seals The new HENSOMASTIK® Acrylic is a ready-for-use acrylic based liquid filler especially designed to form a fire penetration seal in linear joints and gaps where wall and floor constructions made…
Water-based sealant for penetration seals and fire-resistant edge, wall and ceiling joints The HENSOMASTIK® Acrylic is a flexible white acrylic penetrations sealant with ablative fillers, especially formulated to provide excellent fire resistance and fire-resistant edge, wall and ceiling joints and…
Fire protection solution for electrical installation boxes and power sockets In general, fire protection walls must not have any openings, but in practice it is sometimes unavoidable to route electrical supply lines through it or to place electrical installation boxes…
HENSOGRUND WB Green water based, single pack acrylic primer for structural steel members derusted by hand, galvanised or blasted and for stainless steel surfaces. Substrates / Properties Substrates: Steel (Sa 2 1/2 , St 3, PSt 3), galvanised steel, stainless steel…
Water-based 1C system, maintenance-free, for indoor use Approved in accordance with BS 476 Certifire No. CF 5678 Main uses Structural steel profiles as columns / beams / girders / I- / H-sections Open steel profiles: R15 – R60 for beams…
HENSOTHERM® 7 KS Fugenelement for easy and fast sealing of joints between cellular concrete, concrete, hollow blocks and brickwork for indoor and outdoor applications with a maximum joint width up to 100 mm. Fire resistant rate up to EI 90…
Solvent-based 1C system, maintenance-free, for indoor and outdoor use Tested according to EN 13381-8 and approved according to EN 13501-2 ETA No.: 20/1259, CE marking in accordance with 93/68/EEC Colour: RAL 9002 Main uses Open profiles R30 – R60 for…
HENSOTHERM® V 60 is a thinner and used to adjust the viscosity of the solvent-based fire protection coating HENSOTHERM® 310 KS rapid and to clean the equipment after use. HENSOTHERM® V60
HENSOTHERM® 7 KS Gewebe 125 is used as an intumescent pipe sleeve for non-combustible pipes (metal pipes/coolant pipes) with line insulations in flexible walls, rigid walls and rigid floors in the HENSOMASTIK® Mixed Penetration Seal EI 30 / EI 60…
HENSOTHERM® 7 KS is an intumescent fire-protection coating for use on both metal and plastic surfaces. The coating contains no halogens, APEO, borates, fibres or plasticisers. The coating is non-VOC and thus fulfils the criteria of the LEED credit EQ c4.2. Under…